Description + Mechanical aptitude + Operation of equipment + Assembly + Attention to detail/inspector like qualities + Questions the smallest cosmetic or measurement detail + Follows and completes paperwork requirements. Any deviations, questions are asked. + Procedurally oriented. + Does not deviate from procedures. + If procedures are unclear ask for clarification. + Craftsmanship Mentality + Ability to be cross trained on multiple areas + Part marking + Machine Center + Drill Center + Rivet Insertion + Deburr + Aerospace Drawing interpretation/basic specification training requirements + High School Diploma or GED is preferred + Selected candidate will be asked to pass a battery of tests. + Good Attendance is a requirement Equal Opportunity Employer/Protected Veterans/Individuals with Disabilities The contractor will not discharge or in any other manner discriminate against employees or applicants because they have inquired about, discussed, or disclosed their own pay or the pay of another employee or applicant. However, employees who have access to the compensation information of other employees or applicants as a part of their essential job functions cannot disclose the pay of other employees or applicants to individuals who do not otherwise have access to compensation information, unless the disclosure is (a) in response to a formal complaint or charge, (b) in furtherance of an investigation, proceeding, hearing, or action, including an investigation conducted by the employer, or (c) consistent with the contractor’s legal duty to furnish information. 41 CFR 60-1.35(c)