Job Summary This position works in the manufacturing division that further assembles product, cut to length and various other finishing of products. This position is for 2nd shift, Monday through Friday 3:00 pm - 11:30 pm. Essential Duties and Responsibilities • End finish operations • Read DPR / determine quantity required • Standard packaging label (spec #40001) • Complete DPR paperwork (spec#00005 & 00006) • Collection of products • Report processing difficulties to supervisor (or designate) • Various cut to length operations • Use of weigh count scales • Miscellaneous in-process product inspection • Testing of products • General housekeeping and sanitation • General maintenance activities • Dimensional measurement of extruded tubing • Visual inspection of extruded tubing • Other duties as assigned Qualifications Qualifications • High School Diploma or equivalent • 1+ years of on-the-job experience in medical device manufacturer or component manufacturer • Able to perform repetitive tasks for a minimum of 8 hours each workday • Hand dexterity is essential, as small parts need to be assembled • Good eye-hand coordination is required • Able to use, but not limited to, pin gauges, ruler, tape measure, and caliper • Worker should be able to meet known targets • Able to work independently or in a team • Able to maintain accurate records Physical Demands • Continual lifting up to 50 lb, gripping, turning, finger dexterity, and hand /eye coordination is required throughout the shift. • Long hours: 8 + hour shifts, mostly standing occasionally rotating into a sitting position. • Position requires good vision to inspect product for quality. Must be able to distinguish colors for some positions. Must be able to wear protective eyewear. Work Environment • Exposure to noise is present. Safety equipment such as protective eyewear is required, however hearing protection is optional and both are provided by the company. • Manufacturing, warehouse and clean room environments.