Job description Functions and Responsibilities: + Confirm vise is true to machine + Review set up sheet and pulled tools + Provide feedback after tooling is set of any concerns to team + Run Single control and small vertical machines + Use appropriate machining tools: go/no go gauges and calipers for inspections compare to blue print + Set up, operate, and tend to preventative maintenance for CNC equipment + Interpret and work from complex drawings and blue-prints + Identify non-conformances during inspection of component parts and properly document such non-conformances + Notify supervisor when work received does not meet the specifications required by previous operators + Responsible to record an accurate log of job times and specifications for audit reports + Maintain clean equipment/tools and work area + Follow established safety procedures Education: + High School/GED - required + 1 year machining certification - preferred Experience: + 1 – 3 years of machining experience + 1+ years of Haas Control - preferred Physical Demands: The physical demands described below are representatives of those that must be met by an employee to successfully perform the essential functions of this job. Reasonable accommodations may be made to enable individuals with disabilities to perform the essential functions. While performing the duties of this job, the employee is required to: + Frequently: sit, grasp/hold, fine manipulation of both hands + Occasionally: reach at shoulder, lift/carry, and walk + Seldom: stand, reach below shoulder, reach above shoulder Percent of job performed per Hours Worked: 0% - 15% Seldom 16% - 33% Occasionally 34% - 65% Moderate 66% - up Frequently