Summary You will serve as a Pipefitter in the Production Division, Public Works Department Oceana, of Naval Facilities Engineering Systems Command Mid-Atlantic. Responsibilities You will interpret pipefitting assignments (e.g., work orders, building plans, blueprints) to meet workload requirements. You will make pressure joints (e.g., threaded, flanged welded, flange bolted, brazed, soldered, silver brazed) to install piping sections. You will calculate pipe, joint, or valve sizes needed to support pressures of systems. You will inspect and test systems for damage, leaks, and blockages in lines, expansion joints, valves and traps. You will determine causes of problems and recommend corrective action on pipefitting work. Requirements Conditions of Employment Qualifications Although a specific length of time and experience is not required for most trade and labor occupations, you must show through experience and training that you possess the quality level of knowledge and skill necessary to perform the duties of the position at the level for which you are applying. Qualification requirements emphasis is on quality of experience, not necessarily the length of time. Your qualifications will be evaluated on the basis of your level of knowledge, skills, abilities and/or competencies in the job elements and screen out listed below. This job has a screen-out element which will be used to determine minimum eligibility for this job. Applicants who do not receive a minimum of two points on the screen-out element(s) will be found ineligible. The Screen-out Element for this position is: The ability to perform common tasks including 1) Assisting in installing, modifying, maintaining, troubleshooting and repairing industrial or domestic high-temperature water and high-pressure piping systems and equipment; 2) Assisting with planning, laying out and installing piping systems and equipment from blueprints, sketches, etc.; 3) Assisting with performing soft soldering and silver brazing with an oxyacetylene torch. You work under close supervision of a work leader or journey-level employee who observes tasks in progress and upon completion to make sure they are properly performed. Applicants must meet the requirements of the Office of Personnel Management (OPM) Job Qualification Handbook for Trades and Labor Occupations. Additional qualification information can be found at: https://www.opm.gov/policy-data-oversight/classification-qualifications/federal-wage-system-qualifications/#url=List-of-Approved-Job-Elements Experience refers to paid and unpaid experience, including volunteer work done through National Service programs (e.g., professional, philanthropic, religious, spiritual, community, student, social). Volunteer work helps build critical competencies, knowledge, and skills and can provide valuable training and experience that translates directly to paid employment. Education Additional Information This position is covered by the Department of Defense Priority Placement Program. Additional vacancies may be filled by this announcement. A tentative offer of employment will be rescinded if the selectee fails to meet the pre-employment requirements, including failure to report to any of the scheduled appointments. If you are unable to apply online and request information about the Alternate Application process, please contact the Department of Navy's Employment Information Center. Federal annuitant information: The selection of an annuitant is subject to the Department of Defense and Department of the Navy policy on the employment of annuitants. Policy information may be found at: http://www.secnav.navy.mil/donhr/Documents/CivilianJobs/FedCivAnnuitants.pdf PPP applicants will be placed at the FPL, if determined Well Qualified (WQ). To receive priority consideration, the FPL must be the same grade level or equivalent of the retained grade or the grade held immediately prior to separation. ICTAP Applicants: To be considered well-qualified and exercise selection priority as an ICTAP candidate for this vacancy, displaced Federal employees must satisfy all qualification requirements for the position and receive a rating in the highly qualified category or higher. ICTAP candidates must provide copies of all of the following documentation at the time of application: 1) agency notice; 2) most recent performance appraisal and 3) most recent SF-50 or notification of personnel action that includes position, grade level, and duty location. Applicants who do not provide this documentation will not receive consideration as an ICTAP candidate. For more information about ICTAP eligibility please review the following link: https://www.usajobs.gov/Help/working-in-government/unique-hiring-paths/federal-employees/ictap/ Military Spouse Preference applicants will receive priority consideration at the Full Performance Level (FPL) and if determined to be Best Qualified at the FPL, and selected, must be placed at the FPL. A BQ military spouse possesses knowledge, skills, abilities, and competencies comparable to others who meet the competitive referral criteria for the specific position. PHYSICAL EFFORT Incumbent makes repairs and installations from ladders, scaffolding, and platforms, and where the systems and equipment worked on are in hard-to-reach places. The work involves standing, stooping, bending, kneeling, climbing and working in tiring and uncomfortable positions. May handle, lift, carry, and set up parts and equipment that weigh up to 50 pounds. Occasionally, may lift and carry items that weigh over 50 pounds. WORKING CONDITIONS The work is done inside and outside, and is usually dirty, dusty, and greasy. May be required to make installations and repairs in areas where bad smelling fumes are present. There is frequent exposure to the possibility of uncomfortable heat conditions. The work may involve exposure to the possibility of strains, cuts, scrapes, bruises, burns, and infections. May occasionally be exposed to the possibility of broken bones.